Publish Time: 2025-05-29 Origin: Site
GBY10 Mining Intrinsically Safe Acceleration Sensor
Product Overview
The sensor is an intrinsically safe acceleration sensor for mining use, providing a 4-20mA current signal output, proportional to the vibration acceleration of rotating machinery shaft tiles or bearing seats. The current range of 4-20mA is proportional to the vibration measurement value and corresponds to the measurement range are connected via the “analog output” cable terminals.
Used in rotating and reciprocating machines, e.g. fans, centrifuges, pumps, electric motors, gearboxes, industrial fans, heat exchangers/cooling towers, air-cooled island fans, generators, piston compressors, centrifugal compressors, rock crusher/coal mills, compressors, pumps, coal mills, etc.
Product Features
Embedded precision circuitry, 4-20mA output; for equipment failure vibration acceleration measurement; isolated floating, industrial field monitoring, strong anti-interference performance.
Product Picture
| | |
| | |
Performance Parameters
Temperature Curve | Electrical connection |
| |
Explosion-proof Certificate
Coal Safety Certificate
Installation Notes
1. Mounting method
When choosing the installation of the sensor should carefully consider the different mounting methods may have an impact on the amplitude and frequency of the sensor. Sensors can be mounted in a variety of ways: hand-held probes, glued, magnetic mounts, threaded mounts, etc. Different mounting methods produce different mounting stiffnesses, resulting in changes in the measurement frequency of the sensor. Different mounting methods produce different mounting stiffness, resulting in changes in the sensor's measurement frequency, the higher the stiffness, the wider the measurement frequency. Therefore, when installing the sensor, it is best to bolt the sensor directly to the object to be measured.
2. Mounting surface
Sensor bottom surface finish to <10μm, but also hope that the user of the object to be measured on the surface grinding, improve the finish and smoothness, so that the object to be measured to install the surface roughness of less than 10μm. Clean the bottom surface of the sensor and the mounting surface to ensure that the surface is free of foreign matter.
3. Bolt connection method
Bolt connection is the most reliable installation method, first of all, in the clean and flat mounting surface to drill a mounting threaded hole (hole depth should be longer than the bolt). Secondly, in order to ensure effective contact between the upper and lower end surfaces, it is best to apply a layer of grease on the bonding surface to increase the contact stiffness, which ensures that the entire bottom surface of the sensor can be well rigid contact with the object to be measured. Finally, use a torque wrench to install the sensor to the mounting surface, the installation of the screw holes must be perpendicular to the surface, the installation torque of 2.5 ~ 5Nm.
4. Magnetic mounting method
When installing the magnetic base, due to the strong suction force of the magnetic base, so special attention should be paid during installation. Avoid direct vertical adsorption on the mounting surface during installation, as vertical adsorption will produce large transient impacts, which may affect the testing accuracy of the sensor. The correct method is to install it at an inclined angle.
Scope of use
Scenarios of use
Yangzhou Xiyuan Electronic Technology Co.,Ltd.
#77 Yeqiao Road, Liandong U Valley slender West Lake Innovation port, building 10-2,Hanjiang District, Yangzhou,Jiangsu,China
Mobie Phone: +86 180-5105-8377
Tel: +86 514-82885589
Whatsapp:+86 182-6066-6867
Email: sale1@yzxyt.com
Fax: +86 514-82885089