Views: 0 Author: Site Editor Publish Time: 2026-11-19 Origin: Site
This solution is designed around dual‑channel orthogonal eddy‑current displacement measurement, synchronous data acquisition and spectrum analysis.
Vibration sensors were originally planned for shaft‑system condition detection. Instead, eddy‑current displacement sensors are adopted to directly measure radial displacement variation of high‑speed rotating shafts.
Maximum equipment rotating speed: 150 000 RPM Corresponding shaft rotational frequency: 2500 Hz
Two mutually perpendicular eddy‑current displacement sensors are deployed to perform synchronous measurement on two radial directions (X and Y) of the shaft system.
Q: If only one eddy‑current sensor is used, merely single‑direction shaft displacement X(t) can be obtained, and the shaft center’s motion status within the two‑dimensional plane cannot be evaluated. Therefore, the recommended configuration is: one probe for X‑direction plus one probe for Y‑direction, with the two probes arranged at 90° to each other, acquiring X(t) and Y(t) signals.
The following parameters can be further calculated:
X‑direction displacement
Y‑direction displacement
X/Y peak‑to‑peak value
X/Y spectrum
Frequency components such as 1X, 2X, 3X, 4X
Shaft‑center orbit
Shaft‑center offset
Comprehensive radial displacement
This constitutes the primary advantage of this solution compared with a single vibration sensor.
The following items need to be confirmed:
Shaft material
Shaft diameter
Surface roughness
Surface plating
Presence or absence of keyways
Presence or absence of threads
Visible machining marks
Mechanical run‑out of the shaft
Principle of eddy‑current sensors: they measure variation of relative distance between probe and shaft surface.
The practical measurement result can be expressed as: Measured Result = Shaft Mechanical Movement + Mechanical Run‑out + Electrical Run‑out + Probe Installation Error
Accordingly, mechanical run‑out and electrical run‑out must be taken into consideration for high‑speed shaft projects.
Under operating conditions of 150 krpm, existing 10 kHz eddy‑current sensors are applicable for shaft‑system displacement / vibration analysis.
Yangzhou Xiyuan Electronic Technology Co.,Ltd.
#77 Yeqiao Road, Liandong U Valley slender West Lake Innovation port, building 10-2,Hanjiang District, Yangzhou,Jiangsu,China
Mobie Phone: +86 180-5105-8377
Tel: +86 514-82885589
Whatsapp:+86 182-6066-6867
Email: sale1@yzxyt.com
Fax: +86 514-82885089