 |
ST31D20MA
Either outputs a speed (4-20mA) and a temperature signal (4-20mA) simultaneously.
Bragg isolation output, industrial site monitoring, strong anti-interference performance
Bragg is mainly used to measure the absolute vibration velocity of equipment fault
 |  |
Connceting Cable |
Temperature Curve |
Installation Instructions | Wiring Instructions |
The mounting base is connected with the casing of the measured point by M6(optional M8, M10) bolts. Open an M6(M8, M10) mounting hole about 6mm deep at the measured point, and tighten the sensor and the mounting hole with M6(M8, M10) bolts. | 1 (white) : +24V power supply (speed) 2 (red) : 4 ~ 20mA (speed) 3 (yellow) : +24V power supply (temperature) 4 (blue) : 4 ~ 20mA (temperature)） |
Either outputs a speed (4-20mA) and a temperature signal (4-20mA) simultaneously.
Bragg isolation output, industrial site monitoring, strong anti-interference performance
Bragg is mainly used to measure the absolute vibration velocity of equipment fault
| |
Connceting Cable |
Temperature Curve |
Installation Instructions | Wiring Instructions |
The mounting base is connected with the casing of the measured point by M6(optional M8, M10) bolts. Open an M6(M8, M10) mounting hole about 6mm deep at the measured point, and tighten the sensor and the mounting hole with M6(M8, M10) bolts. | 1 (white) : +24V power supply (speed) 2 (red) : 4 ~ 20mA (speed) 3 (yellow) : +24V power supply (temperature) 4 (blue) : 4 ~ 20mA (temperature)） |
